Lots of streaking going on, and we don’t mean the clothe-less type. These photos were taken in Highland Park, an Avon, Ohio community. Clearly, the “algae inhibitors” didn’t do much good. Since approximately 1/2 the view of all homes is the roof, think of how much nicer these once beautiful homes would look with no streaking. Metal roofs never streak, of course. Not now, not 50 years from now.
Verbatim, this is a printed statement from a GAF Smart Choice Shingle “Lifetime” Limited Warranty. If you’ve installed asphalt shingles of any kind since September, you have cause for concern….
“All self-sealing shingles, including GAF’s, must be exposed to warm, sunny conditions for several days before they completely seal. Before sealing occurs, shingles are vulnerable to blow-offs and wind damage. Shingles installed in fall or winter may not seal until the following spring. Shingles installed in the fall or winter may not seal until the following spring. Singles which are not exposed to direct sunlight or to adequate surface temperatures or that are not fastened properly may never seal. Failure to seal, blow-offs, and wind damage under these circumstances result from the nature of self sealing shingles, not a manufacturing defect, and are not covered under this warranty.”
Integrity of an installer means everything. We’ve seen many asphalt roofs installed this winter by unscrupulous asphalt roofing installers. Did you get a “better deal” because the company was slow in the winter? The best asphalt roofing companies simply DON’T install asphalt roofing in the winter months. Fortunately, metal can be installed any time of year as there are no “blow off” or “sealing” issues related to metal roofing.
There’s always a right way and a wrong way to do just about anything. Sadly, there are metal roofing companies that take WAY too many shortcuts. From using 30# felt as under-layment, installing closed valleys instead of open valleys, to not kerfing chimney flashing, we’ve seen it all. Don’t be one of the people who have to call us because there were problems after your metal roof was installed improperly. Let us do it right the first time.
In the case of closed vs. open valleys, it’s MUCH easier and faster (making it cheaper) to install a closed valley vs. an open valley. Closed valleys tend to clog and become gathering places for debris and leafs. Below, you’ll see an open valley that we’ve installed, followed by two photos of closed valleys that we didn’t (and wouldn’t) install. The photo with the valley cap off shows you how the installer effortlessly cut the panels and installed a decorative piece over them, plus the debris that’s collected. These types of shortcuts may save you some money initially, but will cause you long term pain and frustration over time. Let the experts at Distinctive Metal Roofing install your metal roof the right way the first time and never worry about your roof again!
Don’t forget, we provide FREE ESTIMATES! If you are ready, or thinking about replacing your roof, don’t hesitate to call!
Once again, Spring is here with the potential for both wonderful, and not so wonderful weather. Predictions have been made for a rough Spring. Should hail appear during a storm, it’s important to inspect your roof for hail damage. Hail can cause significant granule loss wherever it strikes which leads to direct sun exposure to the underlying asphalt on the shingles it effects. This will lead to cracked shingles over time and the potential for leaks. Have an insurance inspector analyze the damage after a storm if you suspect damage to your asphalt roof.
Metal roofing isn’t subject to hail damage like an asphalt roof is. Corrugated steel panels are dimpled to begin with and standing seam roofs don’t generally show dimpling. Both products are warranted for hail penetration. Kassel and Irons steel roofing is warranted for a lifetime against hail and wind uplift on a non pro-rated basis. You won’t find asphalt roofing manufacturers offering any protection for hail damage in their warranties.
A lot of people assume that because asphalt roofers stop working when the weather gets cold, all roofers do. Fortunately, we’re able to work year ’round because, unlike asphalt shingles, metal roofing doesn’t need to “seal”, and it doesn’t become brittle as the temperature drops. So give a call… why wait until Spring, or for your current roof to fail completely and cause interior damage during thaws?
Always on the lookout for new permanent products that may provide a good alternative to asphalt, we’ve examined several manufacturer’s synthetic, or “composite” slate shingles. Why wouldn’t we consider them? They’re gorgeous, much lighter than slate, a fraction of the cost of slate, and much easier to install with no maintenance needed. We were hopeful that we had found a compliment to our metal roofing selections for those interested in a slate roof, without the budget for slate.
As usual, we explored the warranty. And keep in mind, this is a material that rivals metal from a cost perspective, though again, much less expensive than real slate. What did we find in the warranty of several manufacturers? Believe it or not, pro-rated warranties, just like these companies provide for their asphalt products. The best of the warranties offered its 50 year pro-rated warranty with a non pro-rated period for “7 years against manufacturing defects that cause leaks”.
However, our biggest cause for concern came from a paragraph under “LIMITATIONS”. It read “Shading, stains, or discoloration to the shingles arising from outside sources such as but not limited to the sun, algae, fungus, moss, lichens or other vegetation, mole or mildew growth, or paints, chemicals or other similar materials.” Alright…so now we know that there’s no warranty against fading (shading , as they term it) or discoloration from the sun…PERIOD. Keep in mind that this is a polymer (plastic) material.
Conclusion? We’re not going near this product any more than we’re going near an asphalt product. Both appear to be temporary, with pro-rated warranties. Do you expect more from your roofing warranty? Let us know…we’d love to hear from you.